FETtec KISS AIO G4 - N Flight Controller w/ 35A 4-In-1 ESC

Description

The next generation of FETtec's popular AIO KISS flight controller has arrived! Featuring the latest STM32 G4 MCU with math accelerator for the ultimate in flight performance, MPU6000 gyro, 2 dedicated BECs for 5V and 16V switchable power, DSHOT2400, 20x20 mounting holes, and 4-In-1 ESC with full sine wave control.
This new "N" version simply means there is no onboard analog OSD chip. Due to global shortages, the OSD chip was removed. This only affects analog systems, there are no other restrictions and you can use the full potential of this FC as you are used to. The use of external OSD boards and digital FPV systems still work fine.
The  is perfect for analog users still wanting OSD.
Specifications
:
FLIGHT CONTROLLER
Latest STM32G4 Processor
170Mhz + Math accelerator
MPU6000
Supply voltage 12-25V (3S-6S Lipo voltage)
2x dedicated onboard
5V BEC for VTX (max. 600mA each)
5V BEC for RX 5V/16V BEC for VTX (switchable and real Pit*)
1x 8 pin connector for solder free VTX, cam connection and OSD or digital systems
VCC, GND, Video in, Video out, BEC 5V/16V, VCS/TX3, RX3
2x 4 pin connector for receiver and VTX
Signal, telemetry, 5V, gnd
Gnd, 5V, TX1, RX1
5 UART serials
UART 1 free
UART 2 used for Receiver
UART 3 free
UART 4 free
UART 5 used for ESCs / TLM / Onewire
Solder pad for RGB LEDs
Supported ESC protocols
PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
KISS FC firmware
*Real Pit-Mode:  A power supply pin which is remotely switchable
ESC
Active current limiting @ 35A
Input voltage: 3s-6s
High-quality 40V MOSFETs
STM32G071 @ 64MHz up to 128 kHz Motor PWM
Full sine wave control
Automatic input signal detection
PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
FETtec ESC firmware
Connector type:  JST-SH-1mm
Dimensions
:
Maximum outside dimensions:  30 x 37.5mm
Mounting hole arrangement:  20 x 20mm with M2 mounting holes (expandable to M3)
Overall Height:  7.9mm
Weight:  8.9g
Software:
Kiss Firmware - Software update via FETtec Configurator
FETtec ESCs Firmware - Software update via FETtec Configurator
Includes
:
1x FETtec KISS AIO G4 - N Flight Controller w/ 4-In-1 ESC
1x Capacitor 50V 470uF
2x 4 pin cable with JST connector on one side
1x 8 pin cable with JST connector on one side
Standoffs