-40%
lux v2 flight controller
lux v2 flight controller
lux v2 flight controller
lux v2 flight controller

lux v2 flight controller

$ 10.56

Availability: 52 in stock
  • Model: lux v2
  • Type: Flight Controller
  • Brand: Lumenier
  • Condition: Used
  • Compatible Vehicle Type: Quadcopters & Multicopters

    Description

    Flight controller has been used. Seems to function properly when plugged into Betaflight.
    Hardware Features
    New in V2
    - Dedicated UART for RC RX use, no need to solder a jumper to select PPM/SRX anymore.
    - Dedicated telemetry UART, this brings the total to 5x plus USB.
    - SD Card slot for BlackBox data recording
    (SD card not included)
    - Low noise MPU6000 SPI Gyro.
    - USB detection can disable things like buzzer when configuring on the bench.
    - New ultra low noise regulators for MCU and IMU power systems.
    - USB Conflict resolution
    - Hardware inversion, SBUS or telemetry can be used on any of the
    3
    available hardware serial ports. USB will not interfere with peripherals.
    - High Speed SPI 8kHz Gyro
    - MPU interrupt connected to F3, allowing the F3 to know immediately when fresh data is available.
    - Dedicated Boot button for easy firmware flashing.
    - Reinforced solder pads for trouble-free direct soldering.
    - Extremely low profile design.
    - Recessed, sideways pin headers. Also enables soldering of all wires directly to pads without use of any pin headers.
    - Integrated FRSky RSSI Filter (RC filter).
    - Input voltage 6v to 24v. Power the board directly from flight pack up to 6S (on 'BAT' pad only!).
    - VIN + VBAT merged - A single wire to power the board will provide voltage input and Telemetry/OSD voltage data.
    - Filtered voltage output - output 5v 1A (and 3.3v where applicable) to power peripherals such as GPS, RX, BLACKBOX, OSD. 5v/3.3v RX selectable.
    Note: RX pad is dedicated to UART 4 in the Configurator.
    Software/Hardware Features
    - Betaflight support (
    Supports new DSHOT protocol
    )
    - Cleanflight support (RACE target).
    - BLHeli passthrough flashing supported by hardware
    - Raceflight ready
    Specifications
    - STM32F303
    RCT6(256kB flash)
    32-bit processor
    - MPU6000 SPI Gyro/Accelerometer
    - Micro SD memory card slot
    (SD card not included)
    - High quality, gold plated PCB
    - Highest quality components, individually sourced to meet Lumenier standards
    - Micro USB connector for programming
    -Dimensions:
    36x36x6mm (includes USB in height)
    Mounting Holes:
    30.5mm square to center of holes
    Weight:
    5g