TBS Podracer AIO

Description

TBS partnered with Zeez RC to make this awesome whoop AIO. Introducing the TBS Podracer AIO, the board is designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact and lightweight core for your build..
The FC is equipped with F4+MPU6000 and the ESC is capable of True 30A current running BLHeli32. This board is versatile enough to run on your cinewhoop, 4/5" racer like the podracer and long-range cruiser like the .
Specifications
:
FC Side
Mounting holes: 25.5×25.5 mm / M2 holes
Up to 6S input
5V BEC up to 1.2A continuous
STM32F411 MCU (Support BetaFlight, EmuFlight)
MPU6000 Gyro/ACC
OSD chip Onboard (AT7456E)
2 available UART
LC Filter for 5V VTX and Camera
Direct solder connection for TBS Nano RX and TBS Unify Pro32 Nano
Support programmable LED like WS2812 etc
Built-in current sensor
ESC Side
Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
Input voltage: 2S-6S Lipo
Continuous current: 30A
Peak current: 35A
ESC firmware: BLHELI 32
PWM Frequency Range: 24KHz up to 96KHz
GPS Installation
Because of the phyiscal limitations, installing a GPS module to the FC will require a few extra steps to remap the board's resources.
Note: The follow steps will disable LED and FC's SmartAudio and use as softserial for GPS.
How To
1. Flash the board with Target: STM32F411
2. Download the Config file . Then load it on the board.
3. Wire the GPS as shown
Includes
:
1x TBS Podracer AIO >1x Capacitor
1x AWG Cables Set with Shrink Tubes
4x Mounting Gromets
1x XT60 (Male)
1x XT30 (Male)
1x Pinheaders set for TBS VTX and RX